日鼎伺服参数设置方法按键说明: 操作说明: 线路连好之后即可上电,如果没有出现报警就可进行参数的设定。 : Pn-01 ; 秒以上,面板显示 Pn-01 的参数值; . 键改变值的大小,想移位时按键。改好数值后按键1 秒以上,显示 Pn-01 表明参数值成功写入; ,面板显示: PN-02 ,重复第二步的操作设定 2 号参数。 5. 以同样的方法设定其它参数。注: 全部参数设完之后请务必先关掉电源,然后重新上电。参数初始化: ※ 1) NG 显示的原因? RUN 信号接通时?参数 29 号( 禁止参数重写) 为「 1: 不可重写」时 Parameter settings 切换模式(MODE) 。删除(ESC) 。将设定位向右侧移位(SHIFT) 。确定模式与数值(ENT) 。确定的时候要按住此键 1 秒以上。选择伺服模式。为数值的减量(- 1)。选择伺服模式。为数值的增量(+ 1)。 Touch panel introduction : Operation introduction : Power on after wiring the drive, 改为 T he parameters can be set only when no alarm displays on the screen. the button the screen will display : Pn-01 ; the button more than 1s, the screen will display the value of Pn-01 ; the or button to change the value ofa parameter , if you want to shift , push the button. When changing the value, the scre en is blinking. P ush the button more than 1s, the scre en will stop blinking witch means the parameter has been modif ied essfully ; the button to return ; the button , the sc
日鼎伺服参数设置方法 来自beplayapp体育下载www.apt-nc.com转载请标明出处.