CCNA-RIP实验.docx

实验介绍
本实验所用设备为:三台带有S0口和一个E0口的路由器,三台PC
实验目的
灵活掌握RIP的动态路由配置
实验拓扑图
实验步骤
R1的配置
R1#enable
R1#conf
R1#configure
Configuring from terminal, memory, work [terminal]? t
Enter mands, one per line. End TL/Z.
R1(config)#int e1/0
R1(config-if)#ip add
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#int s2/0
R1(config-if)#ip addr
R1(config-if)#no shutdown
R1(config-if)#clock rate 56000
R1(config-if)#no shutdown
R1(config-if)#exit
RIP协议启用前的路由表
R1#show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is not set
C is directly connected, 1/0
C is directly connected, Serial2/0
启用RIP
R1#en
R1#conf t
Enter mands, one per line. End TL/Z.
R1(config)#router rip
R1(config-router)#net
RIP协议启用后的路由表
R1#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
E1 - O